COMPLETING THE COURSE
To complete this course you must complete the interactive simulation(s) and pass the assessment(s). Typical courses contain a post-test, on which you must receive a score of 70% or higher to pass.
Assessments: If you have failed an assessment you can try again, after submission, by clicking the “retake assessment” button provided.
Interaction Simulation: If any steps have been skipped within the simulation you can access those steps by entering the simulation and viewing the checklist by clicking the checklist button in the bottom toolbar. Skipped steps will be marked with a red X. Click on any applicable step within the checklist to visit that step and complete it.
This course can be used in different ways based on the goals of your education experience. The learning mode you select will determine what content is available during the course session. Full and overview modes allow you to quickly select all or the minimum amount of content. To choose
When you begin the course you can choose your desired learning mode. Please note that once you navigate forward in the course you cannot change modes within this session.
1. Exit Course:Leave Course at Any Time
2. Left Navigation: Chapter/Section List
3. Info Bar: Current Chapter/Section and Page
4. Content Area
5. Prev and Next: Proceed to next page or return to previous.
6. Help Link: Access Help Document
PLUGIN (UNITY WEB PLAYER) TROUBLESHOOTING
Ensure web player is installed
o Install unity web player by clicking on the “unity web player - install now" banner as seen in the image below or by visiting https://unity3d.com/webplayer. Follow the prompts through the plugin installer.
o If the simulation doesn’t start immediately after the installation, close your browser and re-open the browser and then launch the simulation again.
Additional troubleshooting resources are available at the Unity 3D website:
If you are experiencing issues you may want to try to clear the cache in your browser, close your browser and then access the course again.